LWcad 2018 for LightWave (on LW 2015.3 / 64)

1. Make a NURBS sphere (8 polys)
2. Save the Object
3. Close Object
4. Open the Sphere.lwo again
5. Select polys (now you count 16 Polys)

after every file-saving the count of polys is doubling

I have realized that after several file saves :
a small nurbs object suddenly had thousends of polys
8-)

OK, I can use the tool " join curves" ..
but often I forget it ..

Can you check that please, Viktor?!

salute
Peter

Sorry for delay Peter.
This is already fixed in LightWave 2018.
If you install latest LightWave this shouldn't happen again.

Anyway, Today I have finally persuaded LightWave to display UV mapping with LWCAD NURBS surfaces

I will release some news very soon

can you fix that also for LW 2015.3 please ?!

I have to confess that I don't use LW 2018 very often ..

I'm more familiar with the old system ..

the whole setup over the years (plugins / menues / better UI on big screens .. you know)

~~~~~~~

the new NURBS UV looks nice

and I'm happy that we hear some news soon !

Greetings to Bratislava

Peter