hi viktor,

i noticed this while i was playing with the new update and encountered it a couple of times in passing now but just figured i must be doing something wrong... but i do think it's lwcad-

when i perform a round on the top of a rectangular piece of geometry, the edges at the corners pull apart. even on corners where it's not visibly tearing as shown, the vertices end up unwelded.

running:

• windows 10
• lightwave 9.61
• lwcad 5.5

thanks!

jin

I've found the same problem and came here to see if anyone else had notes on it. In my case the geometry happens to be a rectangle with another rectangle "poking" out of the middle of one side. Trying to round all edges and both the convex and concave corners have holes on most intersections (although a few are correct).